It’s about time I posted another tutorial here, don’t you think?
Before all the sniffles and colds get going, how about pretty, quilted tissue box covers. I’d much rather see pretty fabric sitting in my room, than a functional cardboard box!
And this tutorial will explain how to cover a box of any size, so let’s get started!
You Will Need:
Heavy Sew-In Vilene
Non-permanent fabric marker
Cardboard or template plastic
Measure your box:
Take measurements A (short side), B (long side) and C (top). Then add 3/4″ (0.75″) to each measurement (1/2″ for seam allowances, 1/4″ for ease) to get the cutting out sizes.
You can see my measurements in the example below:
So now that you have the cutting out measurements you can either ….
apply all measurements to your exterior fabrics, lining fabric, wadding and heavy sew-in vilene
instead of cutting out the sides, cut and baste an 11″ x 12″ piece of exterior fabric, wadding and sew-in vilene. Once quilted, this is big enough to cut out all 4 sides.
You will also need this template for the openings. I use the larger shape for rectangular boxes and the smaller shape for cube boxes. Cut out the openings and transfer them to card or template plastic.
Use 1/4″ seams
1 If you haven’t already done so, spray baste the exterior fabrics, wadding and vilene together.
2 Quilt as desired (I marked and quilted a 1.5″ diagonal grid, see photo above).
3 Pin an exterior short side (A) right sides together with the exterior top (C). With a pen, mark 1/4″ in from each corner on the short side (wrong side).
4 Sew from marker to marker, starting and finishing with a reverse stitch. Repeat for the other short side.
5 Press the short ends out before attaching the long sides in the same way (remember to mark your 1/4″ points).
6 Repeat steps 3-5 for the lining pieces.
7 Find the middle of the lining top piece (I simply folded it in half lengthways and widthways and finger pressed).
8 Centre your chosen template opening onto the wrong side of the lining top piece and draw around it.
9 Pin the exterior and lining pieces right sides together. Sew along the drawn line, starting and finishing with a reverse stitch.
10 Carefully cut out the opening, leaving a 1/4″ seam allowance. Snip at 1cm intervals all the way around the opening, taking care not to cut into the stitches.
11 Push the lining through the opening and all the way round to the back of the exterior. Iron around the opening to neaten.
12 Top stitch around the opening, 1/8″ from the edge.
13 Pin the exterior sides right sides together. Sew adjacent exterior sides together, sewing from the top down to the 1/4″ marker (fold the top piece out of the way so you can get right down to the 1/4″ marker). Start and finish with a reverse stitch.
14 Repeat step 13 for the lining pieces.
15 Turn the exterior right side out, by folding it out over the lining. On the inside you should be able to see the right side of the lining.
16 Push the lining well into the corners of the exterior cover. Pop in the tissue box and trim off any excess cover and lining level with the edge of the box.
17 Machine tack (large stitch) around the raw edges 1/8″ from the edge.
18 Make enough double fold quilt binding to get around the bottom edges with a couple of inches overlap. Attach, join and finish the binding as you would for a quilt.
Pop in the tissue box and adorn your bedside table!
Or how about a scrappy tissue box cover ….
…. or have some free motion sketching fun!
Whatever shape or design you choose for your cover, have lots of fun!